Harris Sea Salt 10X Weed & Grass Killer, 1 Gallon

In stock

Ready to purchase!
SKU
130230
  $26.99

Description

Sea Salt Plus Vinegar Weed & Grass Killer is a quick-acting, non-selective contact herbicide containing an organic acid for which the residues degrade promptly in the soil. Foliar contact results in rapid desiccation and control of annual weeds and grasses, and top growth reduction of herbaceous perennial weeds and grasses.

Control & Eliminate Weeds

Keep your garden free from unwanted weeds with our selection of herbicides. Weeds can quickly take over and compete with your plants for nutrients, water, and sunlight. Our herbicides are formulated to effectively control and eliminate weeds without harming your plants. From pre-emergent herbicides to prevent weed growth to post-emergent options for existing weeds, we have everything you need to maintain a healthy and weed-free garden.

When & How to Weed-Out Weeds

Grow your Best

Spring into Fertilizing

Help and Advice

Details

Sea Salt Plus Vinegar Weed & Grass Killer is a quick-acting, non-selective contact herbicide containing an organic acid for which the residues degrade promptly in the soil. Foliar contact results in rapid desiccation and control of annual weeds and grasses, and top growth reduction of herbaceous perennial weeds and grasses. For control of established perennial weeds, retreatment may be necessary. This product may be applied up to two days before harvest. Use this product to control weeds that surround all food crops, nonfood crops (ornamentals) and non-production agricultural, farmstead, right-of-way, and institutional land sites. Use to control weeds in interstate freeways/highways, federal and state highways and city/county rods and walkways, railroad vacant lots. Suitable to keep down weeds in all botanical and private association ornamental gardens, kennels, dog runs, and other animal enclosures and walkways. EARLY SEASON ANNUAL WEED CONTROL: Apply this product when weeds are small (3 to 5 leaf stage) and actively growing. Spray this product on unwanted weeds (vegetation) to the point of wetness. For best results spray on dry leaves at temperatures between 50 and 75 degrees Fahrenheit. Conditions of high evaporation rates (temperatures high than 75 degrees Fahrenheit and low relative humidity) may result in reduced efficacy. Since dilution of this product will reduce effectiveness, avoid dilution. See back label for a full list of typical weeds controlled and application instructions.

  • Kills Weeds Fast - Results are often seen immediately with browning and shriveling of unwanted weeds
  • Contains No Glyphosate - Free from chemicals traditionally used in weed killers  
  • Kills a Large Variety of Weeds - Kills chickweeds, moss, crabgrass, clovers, dandelions, and much more

More Information

Container Size 1 Gallon

Product Questions (7)

If your lawn has dog damage, put down some gypsum and soak it all through for at least 6 hours till saturation point. After that you can rake away the dead grass and reseed as normal.
There are many correct ways to Aerate, the least invasive way is biological aeration with C20. You can also do a mechanical core aeration, lay down a layer of compost and gypsum, water all the plugs in and reseed. The timing is far more critical, the...
When discussing weeds, an ounce of prevention is worth a pound of cure. A thick lawn that is watered deeply and infrequently, cut to 3” high and not mechanically disturbed in the spring when most weed seeds are germinating will have less weeds. Putting...
Hand pulling or using an iron based natural broadleaf weed killer are safe ways to weed.
When determining how much grass seed you will need, you must determine your square footage by measuring length multiplied by width.
That depends on what caused the dead patches, if it’s grubs we recommend the bayer dylox grub control. If it’s fungal, Scotts disease X is recommended to stop the spread. If the disease has gotten down to the crown, it is dead and will need to be raked...
Liquid applications are easier to burn with and generally not recommended, as it will be 100% synthetic. With granular applications you have your choice of going for all slow release and non-burning, or a mixture of...
loader
Loading...